Lipo Wiring

                                  

Notes:

When charging below 1.5A (1500mA), it is OK to charge through just the balancer leads ("balance connector only" options in the diagram above).

When charging over 1.5A, it is recommended to charge through the main battery leads, and balance through the balance connector ("using main leads" options in the diagram above). This is because the balancer leads and associated wires are too small to handle higher charge currents and may cause erroneous balancer operation due to potential voltage drop.

You may notice that when any of the options with "using main leads" is selected, one of the balancer wires is unused. This is intentional as a safety precaution. If all balancer wires were used in conjunction with the main leads, and the balancer connectors were inadverdently swapped, damage will result in the balancer wire, connector, battery, or any combination of these! I usually zip-tie each balancer wire to the accociated charging lead for added safety.

Below is a picture of a completed 2s + 2s balancer/charging Y adaptor created with the "using main leads" option. The wire length was properly sized for use with the Hyperion LBA10 balancer unit. Also, the wires were extended to allow enough wire slack for easy placement into a fire-resistant container such as the Lipo Sack, Battery Bunker, etc.