Water jacket for the TP Power 4050, 4060 and 4070 V2 version motors.
53mm (2.09") long, the jacket is long enough to cool the motor well. Yet weighs just 2 ounces.
Installation is a snap! Apply some oil/grease to your motor housing and the o-rings on the jacket, than slide on the jacket.
Approx. 2.09" (53mm) long x 1.74" (44mm) outside diameter.
V1 Motors are a 2 piece design. The front endbell is part of the main center case and NOT screwed on.
V2 motors are a three piece can design. Front and back end plates are both screwed on.
Not logged in
Help & FAQ
© Copyright 2018 - Offshore Electrics
Unauthorized use of any materials presented here is prohibited. Copying or reproducing any elements from this page is not permitted. All prices, descriptions and availability subject to change.